FCB1010- How Do I Set The MIDI Channel?

 

 

 

 

 

 

 

 

 

 

To set the MIDI channel on your FCB1010, do the following:

  1. If FCB1010 is turned on, turn it off
  2. Press and hold the Down button while you turn on the FCB1010.  Keep holding it down for about 5 seconds. When you see the small green light come on, release the button
  3. Press the UP button once.  The green light will have changed to the MIDI Function selection.
  4. Press the 1 button.  The 1 button LED and green light will begin to blink.  The display will change to show you the current MIDI channel for PC command.
  5. Press the UP button once.  The green light will move to MIDI Chann and the display digit will begin to blink.
  6. Press the 0 button and then the 1 button.  This will change it to MIDI channel 1.  The display should now show 01.
  7. Press the UP button once.  The green light will move to the MIDI Config selection.
  8. Now press and hold the Down button for about 5 seconds.  The display will change to 00.

You have now programmed the FCB for the first PC command to MIDI channel 1.  To set a different channel, the steps are basically the same except you enter a different number in the sixth step above.

 


Share this page