LC2412- How Do I Program And Recall Scenes?

 

 

 

 

 

 

 

 

 

 

When presets are stored as a unit, we will call them memories (scenes). In this example, we’ll create and store two presets in BANK 1 of the memory. Start with the DMX dimmer packs set to receive on channels 1 to 3, with lights connected, and with all the LC2412 faders down.

 

The demonstration:

1. Power up the dimmer pack and the LC2412.

2. Press the QUIT button.

3. Use the LC2412 UP and DOWN button to make ‘P’ appear in the BANK display.  It will flash for a few seconds, then remain lit.

4. Push up the MAIN and A faders, and then use faders 1, 2, and 3 in the A PRESET fader section to create a stage design with the lights.

5. Use the UP and/or DOWN button to select BANK ‘1’ in the BANK display, then press the MEMORY button, and the following will appear in the PROGRAM display: SEL. MEMORY _ _ / 01 (top line) and PRESET   ALL (in the second line).

6. Press the FLASH 1 button (in the lower left of the LC2412 front panel), and the display will change to: SEL. MEMORY 01/01 (top line) and PRESET    ALL (bottom line).

7. Press the SOFT A button to choose saving a preset.

8. Press QUIT to leave the MEMORY function.

9. Use the UP and/or DOWN button to make ‘P’ appear in the BANK display.

10. Use the 1, 2, and 3 faders in the A PRESET  section to create another stage design with the lights.

11. Use the UP and/or DOWN buttons to select BANK ‘1’ in the BANK display, then press the MEMORY button, and the following wil appear in the PROGRAM display: SEL. MEMORY _ _ / 01 (top line) and PRESET   ALL (on the bottom line).

12. Press the FLASH 2 button, and the PROGRAM display will change to show:  SEL. MEMORY  02/01  (top line) and PRESET   ALL (on the bottom line).

13. Press the SOFT A button to choose saving a preset.

14. Press the QUIT button.

15. To recall the memory that was just created, start by pulling down fader A ad pushing up fader B.

16. You can now use the faders that are marked ‘M1’ or ‘M2’ in the B MEMORY fader section to recall the two presets that were just saved into memory slot numbers 1 and 2 in BANK 01.

 

Erasing memory settings:

Press and hold the SOFT A and SOFT B buttons, press the FLASH 1 button (in the lower left of the display), and then turn the DATA wheel until ‘DELETE ALL’ appears in the PROGRAM display.  Press the SOFT B button for ‘YES’.  ‘REALLY ALL?’ will appear in the display, and you will then press the SOFT B button for ‘YES’, and all memories will be cleared from the LC2412.

 


Share this page