Does LUCIA have any DSP processing at all?

All Lucia models includes the following DSP processing 

  • Comprehensive DSP features – Per channel presets for high-pass filter, parametric EQ, multi-band compressor, and look-ahead limiter
  • Automatic Dynamic Loudness Contouring™ – DSP automatically adapts to optimize performance at any output level
  • Optimized presets – Available for specific loudspeaker models
  • RS232 – Remote control and monitoring from third party control solutions
  • GPIO – Remote control (e.g. wall panel) for channel switching, level control and integration with paging systems 
  • Intelligent fan control – Silent operation at idle and at lower output levels
  • Fail-safe operation – Comprehensive short circuit, thermal, and under-voltage protection 
  • Configuration software – Windows and Mac software wizard for initial set-up, and advanced editor for preset configuration (LUCIA connection via USB)


Additional features on LUCIA 60/2M, 120/2M and 240/2M only

  • Maximum output power across range of loads –  Power output remains constant into 2, 4 or 8 ohms 
  • Auto Load Sense™ – Proprietary auto-set VPL™ (Voltage Peak Limiter) for optimum performance with any connected load 
  • 4 x 4 mix matrix – Route input signals internally to amplifier or to line-level outputs


Additional features on LUCIA 60/2, 120/2 and 240/2 only

  • Maximum output power across range of loads –  Power output remains constant into 2, 4 or 8 ohms 
  • Auto Load Sense™ – Proprietary auto-set VPL™ (Voltage Peak Limiter) for optimum performance with any connected load 
  • 2 x 2 mix matrix – Route input signals internally to either one or both amplifier channels


Additional features on LUCIA 60/1-70, 120/1-70 and 240/1-70 only

  • Model for constant voltage applications – into 70 V/100 V
  • 2 x 1 mix matrix – Mix two sources to mono or use for source selection

 


Share this page