Products
ENTERPRISE
CREATION
LIFESTYLE
Support
Community
About
Our Tribe
Join Us
Our Story
Buy
Please select a division you are interested in:
Enterprise
Creation
Lifestyle
Sign In
Create MUSIC ID
EN
TC Electronic
TC Helicon
Lab Gruppen
Lake
Midas
Klark Teknik
Turbosound
Behringer
Bugera
EATON - How do I setup my speakers in Single-wire mode?
First link the HF+ terminal to the LF+ terminal and HF- terminal to the LF- terminal, using the links provided in the accessories pack.
For optimum performance in single wire mode, loudspeaker cable connections from the amplifier should be made to the high frequency (HF) terminals of the loudspeaker:
The positive (plus) terminal on the amplifier left channel (marked + or coloured red) must be connected to the positive HF terminal on the left speaker. The left speaker is the
one on the left as you look at the stereo pair from your listening position.
The negative (minus) terminal on the amplifier left channel (marked - or coloured black) must be connected to the negative HF terminal on the left speaker as seen below.
Repeat this connection process for the right speaker. Remember that the positive (+ or red) on the amplifier must be connected to the positive (+ or red) on the speaker and the negative (- or black) to negative.
Select a signal source, such as a CD player, switch on the amplifier and slowly turn up the volume control to check that both loudspeakers are reproducing bass and treble information.
Share this page