StudioKonnekt 48: How to record the DAW main output back in the project?

Question

Is it possible to internally route the signal in TCNear in order to record the DAW Output, without using the S/PDIF Out-> S/PDIF in?

Answer

There is no way to internally route the signal on the same FireWire line, but there is a small workaround:

  • In the DAW channel of TCNear, assign FabrikC1: the signal will go through the Fabrik C plugin. 
  • In your DAW record on a new stereo track using FireWire lines 25 and 26 as input (these are Fabrik C1 outputs). You can use Fabrik C (if you need to control the main output dynamics) or just set it in bypass mode if you don't need it.  
  • Make sure to mute the output of the new track while recording to avoid feedback. 
  • During the next play back, disable the recording to avoid feedback.

Share this page