The LED on my TonePrint pedal doesn't blink when beaming TonePrints

Question

The LED on my TonePrint pedal doesn't blink when beaming TonePrints from my iPhone/ the TonePrint upload doesn't work. What can I do?

Answer

You might need to update the software of your TonePrint pedal before the beaming procedure can work. Go to the TonePrint software download page to download the latest version of the pedal firmware.

If it still doesn't work after updating, please check the following:

  • Please check the TonePrint setting is selected and that the pedal is NOT in bypass.
  • Check that your guitar volume and iOS playback level is turned up.
  • Check that you hold your iPhone close to your guitar pickup with its speaker on the bottom pointing towards the selected pickup, and that the right pick up is selected (see the manual and "HOW TO" section of the app for more info).
  • If your TonePrint pedal is in a chain with other FX pedals, check that all previouspedals are in bypass mode, so the TonePrint audio file doesn't get altered prior to reaching your pedal.


Applicable products:

  • Alter Ego Delay
  • Corona Chorus
  • Flashback Delay
  • Flashback X4
  • Hall of Fame Reverb
  • Gravy Chorus Vibrato
  • Shaker Vibrato
  • The Dreamscape
  • Transition Delay
  • Trinity Reverb
  • Vortex Flanger

Share this page