The overload indicators on System 6000 engines stay on

Question

The overload indicators on my System 6000 engine stay red, after I had a single overload. What is wrong ?

Answer

Please check the Meter Clip Indicator settings on the System 6000s SETUP/SECURITY page.

When Sticky Clip is enabled, the overload indicators will stay on, after an overload has occurred. This is helpful when you are processing some critical material without monitoring it all the time. The overload indicator will then tell you that an overload has occurred during the processing.

You can reset the meter clips on the FRAME page by pressing the RESET CLIP button.


Share this page