UnitY: When attempting to access the card the screen says "NO ASSIGN"

Question

When I try to access my UnitY card the screen says "NO ASSIGN".

Answer

You need to select the correct control surface on the MIDI 5/5 / REMOTE page:

  • First access the MIDI page 5/5 by holding the FLIP button.
  • Select the REMOTE# page corresponding to the slot# where you have installed the TC UnitY card.
  • Move the cursor to the virtual knob next to the REMOTE buttons (see the screen below)
  • Dial the wheel clockwise until you get the TC Electronic screen.

    Image

For more information please refer to page 8 in your user manual.


Share this page